Messages

1

Antique Questions Forum / Manual drill type tool

« on: April 21, 2009, 03:38:34 pm »

Any help would be great...  There is no place to put a drill bit and when you crank the handle on the side in one continuous direction the shaft at the bottom turns about a half turn then backs up a quarter turn then goes forward again half turn and then back quarter, and so on.  It looks like the top handle used to have a stamp on it but I can't read it at all.

2

Antique Questions Forum / Revere Copper and Brass calender pad

« on: April 10, 2009, 09:47:41 am »

I found this, does it look like anything of interest?  It seems old.

Thanks,
Craig T.

3

Antique Questions Forum / Old Oliver Tractor Thermometer

« on: April 10, 2009, 09:45:34 am »

The pictures pretty well explains it all.  I have an entire farm & house full of old antique farming items so I need a good resource to value this stuff.  I was referred to this website.  Thanks in advance everyone!

Craig T.