« previous next »
Pages: [1]

Author Topic: copper smelter figurine with two holder areas  (Read 1096 times)

danagray

  • New Member
  • *
  • Posts: 3
  • Karma: +0/-0
    • View Profile
copper smelter figurine with two holder areas
« on: September 14, 2013, 05:23:52 pm »
Can anyone help me identify this? The markings inside say C. S. 2030. The base is 7 inches wide and 10 inches long, and the height is about 10 inches tall. Thanks.
Logged

mart

  • Hero Member
  • *****
  • Posts: 19849
  • Karma: +122/-1
    • View Profile
Re: copper smelter figurine with two holder areas
« Reply #1 on: September 14, 2013, 08:12:50 pm »
Where is the inscription located ?? Bottom ?? Where did you get this piece ??
Logged

Rauville

  • Hero Member
  • *****
  • Posts: 1812
  • Karma: +109/-0
    • View Profile
Re: copper smelter figurine with two holder areas
« Reply #2 on: September 14, 2013, 08:14:02 pm »
No, I can't identify the manufacturer...but check out the description of this one done in terra cotta.
http://www.ebay.com/itm/Antique-Sculpture-Smoke-Set-Cigar-and-Match-Holder-Set-/380216848824?pt=LH_DefaultDomain_0&hash=item5886b0b1b8
Apparently, it has the same "C.S." marking.
Logged

mart

  • Hero Member
  • *****
  • Posts: 19849
  • Karma: +122/-1
    • View Profile
Re: copper smelter figurine with two holder areas
« Reply #3 on: September 14, 2013, 08:42:58 pm »
This is copper patinated spelter or just a spelter figure copied most likely after a bronze popular at the time, then a thin layer of copper over that !! They usually are faux aged to a bronze look !! These were popular from 1920`s to 1950`s !! You can find many of them online !!
Logged
Pages: [1]
« previous next »